ABSTRACT
This work studied the refining of crude palm kernel oil derived from the kernels within the nut of a palm fruit. This research project was aimed at reducing the non-glycerides present in oil in their crude form using an alkali method of refining. The crude palm kernel oil was first washed with distilled water by heating the mixture in an electric heater for about 2 hours to reduce the impurities present in the oil in their crude form, degummed with phosphoric acid and neutralized with NaOH (caustic soda).The saponification value, iodine value and acid value was analyzed and their values are: for crude palm kernel oil, 33.1, 695.45 and 746.13 respectively, for neutralized palm kernel oil, 11.22, 725.6 and 687.24 respectively
TABLE OF CONTENTS
Cover Page – – – – – – – – – -i
Title page – – – – – – – – – -ii
Certification – – – – – – – – – -iii
Dedication – – – – – – – – – -iv
Acknowledgement – – – – – – – – -v
Abstract – – – – – – – – – – -vii
Chapter One
1.1 Introduction – – – – – – – – -1
1.2 Background Of The Study – – – – – – -1
1.3 Statement Of Problem – – – – – – -4
1.4 Aims/Objective of the Study – – – – – -4
1.5 Scope of the Study – – – – – – – -5
Chapter Two
2.0 Literature Review – – – – – – – -6
2.1 Vegetable Oils – – – – – – – – -8
2.1.1 Classification of Fats and Oils – – – – – -9
2.1.2 Characteristics of oil Classes Lauric Acid Group – 10
2.1.3. Uses of Vegetable Oil – – – – – – 12
2.2 Method of Extraction of Vegetable Oil – – – – 13
2.2.1 Hydraulic or Mechanical Press Extraction – – 13
2.2.2 Solvent Extraction / Leaching: – – – – – 15
2.2.3 Factors Affecting the Rate Of Leaching – – – – 17
2.4 Methods Of Refining Of Crude Palm Kernel Oil – – 19
2.4.1 Chemical / Alkali Refining- – – – – – 19
2.4.2 Physical Refining – – – – – – – 20
2.4.3 Aim Of Refining – – – – – – – – 21
2.5 Origin Of Oil Palm (Palm kernel Oil) – – – – 22
2.5.1 Palm Oil Processing Unit Operations – – – – 25
2.5.2 Kernel Recovery – – – – – – – 26
2.5.3 Principles Of Preservation – – – – – – 27
2.6 Methods Of Treatment – Crude Palm Kernel Oil – – – 28
2.6.1 Degumming Treatment – – – – – – 28
2.6.2 Bleaching Treatment – – – – – – – 29
2.6.3. Deodorizing Treatment – – – – – – 31
2.7 Fractionation Of Palm Kernel Oil – – – – – 33
2.7.1 Dry Fractionation – – – – – – – 34
2.7.2 Detergent Fractionation – – – – – – 35
2.7.3 Solvent Fractionation – – – – – – – 35
2.7.4 Palm Kernel Oil Fractionated Products – – – – 36
Chapter Three
3.0 Methodology – – – – –
3.1 Research design — – – –
3.2 Research setting — – – –
3.3 Instrument for data collection – –
3.3.1. Material — – – – –
3.3.2 Equipments – – – – –
3.3.3 Reagents – – – – – –
3.3.4 Preparation of Reagents – – –
3.4 Refining Procedure – – – –
3.4.1 C.P.K.O and Distilled Water – – –
3.4.2 C.P.K.O and Phosphoric acid – –
3.4.3 C.P.K.O and NaOH (caustic soda) – –
3.4.4 N.P.K.O and Distilled Water – – –
3.5 Characterization of P.K.O – – –
3.5.1 Physical Characterization – – –
3.5.2 Chemical Characterization – – –
Chapter Four
4.0 Results and Discussion – – –
4.1 Results – – – – – –
4.4 Analysis Table – – – – –
4.5 Discussion of Results – –
Chapter Five
5.1 Conclusion – – –
5.2 Recommendation – –
References – – –
Appendixes – – –
CHAPTER ONE
1.1 INTRODUCTION
Palm kernel oil, the second most consumed lauric acid group oil is derived from the dried kernels of the oil palm, ElaeisGuinensis.
Palm kernel oil (co-product of palm oil) and coconut oil comprises less than 5 percent of the total natural fats and oils, but they are important feed stocks of the oleochemical industry. Coconut oil is commercially a major source of lauric acid, together with palm kernel oil and to small extent babassu oil. It belongs to the so called lauric oils, which are characterized by their high lauric oil content of approximately 50 percent.
The lauric oils are highly desirable materials in the oleochemical industry world-wide because of the important of the lauric fraction especially in the manufacture of soap and detergents.
1.2 BACKGROUND OF THE STUDY
Two distinctly different types of oils are produced from the fruit of the south East Asia and African oil palm, ElaeisGuinensis Central American palm ElaeisOleifera.
Palm oil is obtained from the fleshy part of the fruit which resembles an over sized olive about the size of a small chicken
egg. Palm kernel oil is derived from that kernel within the nut. Well over 98 percent of the fatty acids in palm oil belong to the C: 16 and C: 18 group where as approximately 64 percent of the fatty acids in palm kernel oil consist of C: 12 and C: 14 lauric group.
A palm tree produces 10-15 fresh fruit bunches throughout the year weighing 5-23kg (10-50lb) each. The bunches are cut from the tree with knives attached to long poles and are transported to the oil mill. There they are sterilized by steam at about 40psig for 56-75 minutes to deactivate lipase enzymes and loosen the fruits from the stalk.
The fruits are knocked loose from the stalk in thresher drums and passed through a digester to convert the fleshy pulp to mash. Then the mash is pressed by twin-screw expellers or hydraulically to yield red crude oil. The shells of the nuts cracked and the kernels are separated, dried and bagged for later solvent extraction or mechanically pressed in a fashion similar to the processing of raw crop oil seeds.
For satisfactory release of the kernels from the fruits, the requirements are that the oil bearing mesocarp shall be removed and the shells cracked without damage to the kernels.
Palm kernel oil is not usually extracted on the plantations, though occasionally mills contain press designed for this purpose.
The conditions for the release of palm kernel oil, which is
liquid at tropical day temperatures, are different from those of palm oil, but similar to those of copra and hand oil bearing seeds.
Very small quantities are extracted in producing countries by
primitive means but the greater bulk of the palm kernel produced are subjected to industrial process.
Although the extraction of palm kernel oil from palm kernel is not a new project, this project is capitalized on using different types of refining processes to determine the one that will yield a higher output.
Further cultural and agricultural practices differ for its fruit species depending on the type of soil, different samples from different localities were collected in consideration to its essential commercial plantings on which each sample produces high quality fruit/seed and profitable yield. Thus this research study is being conducted.
1.3 STATEMENT OF PROBLEM
Palm kernel oils consist mainly of glycerides, and like other oils in their crude form, may consist of small and variable portions of non-glyceride components as well. In order to render the oils to an edible form, some of these non glycerides need to be either removed or reduced to an acceptable level so as to meet the request of the buyers.
Therefore, this project aims at reducing the non-glycerides present in oil in their crude form using the chemical (alkali) method of refining.
1.4 AIMS/OBJECTIVE OF THE STUDY
- Reduction of the free fatty acids from 5.0 to 0.03 percent of less.
- Production of a fully deodourized product.
- Operation without substantially greater utilities consumption than a standard deodourizer.
- Recovery of the fatty acids from the sparge stream.
- Obtaining a mixture of traicylglycerols with the desired solid content profiles over the range of product used;
- Preparation and storage of semi-solid products with desire textures.
1.5 SCOPE OF THE STUDY
The refining of crude palm kernel oil is converting it to quality edible oil renewing objectionable impurities to the desired levels in the most efficient manner where possible, losses in the desirable components are kept minimal.
After refining of crude palm kernel oil, a good quality has low free fatty acid (FFA) content, does not contaminate with water or other impurities and has a good bleacheability.
DISCLAIMER: All project works, files and documents posted on this website, UniProjectTopics.com are the property/copyright of their respective owners. They are for research reference/guidance purposes only and some of the works may be crowd-sourced. Please don’t submit someone’s work as your own to avoid plagiarism and its consequences. Use it as a reference/citation/guidance purpose only and not copy the work word for word (verbatim). The paper should be used as a guide or framework for your own paper. The contents of this paper should be able to help you in generating new ideas and thoughts for your own study. UniProjectTopics.com is a repository of research works where works are uploaded for research guidance. Our aim of providing this work is to help you eradicate the stress of going from one school library to another in search of research materials. This is a legal service because all tertiary institutions permit their students to read previous works, projects, books, articles, journals or papers while developing their own works. This is where the need for literature review comes in. “What a good artist understands is that nothing comes from nowhere. All creative work builds on what came before. Nothing is completely original.” - Austin Kleon. The paid subscription on UniProjectTopics.com is a means by which the website is maintained to support Open Education. If you see your work posted here by any means, and you want it to be removed/credited, please contact us with the web address link to the work. We will reply to and honour every request. Please notice it may take up to 24 – 48 hours to process your request.
