ABSTRACT
In this work, Transesterification of waste vegetable oil has been carried out using Anthill as the catalyst. Anthill was utilized as raw material for catalyst production for biodiesel preparation. During calcination process, the calcium carbonate content in the anthill was converted to CaO with Al₂O₃ as the promoter and SiO₂ as the support. This calcium oxide was used as catalyst for transesterification reaction between waste cooking oil and methanol to produce biodiesel. The biodiesel preparation was conducted under the following conditions: the mole ratio between methanol and palm oil was 6:1 and with catalyst of 7wt %. The catalyst activation temperature, reaction temperature and reaction time was varied at 600-1000°C, 60-70°C and 1-3h respectively. The maximum yield of biodiesel was 63.14%, obtained at 3h of reaction time and 70°C. Anthill has potential application as a source of catalyst for synthesis of biodiesel of high purity. The catalyst was obtained by calcinations of anthill at 600-1000°C for 3h. The maximum yield of biodiesel produced by transesterification of waste cooking oil with methanol was 63.14%. The operating condition to achieve the maximum biodiesel yield is: the ratio of oil to methanol 1:6, the amount of catalyst 7%, reaction time 3h, reaction temperature 70°C.
vi
TABLE OF CONTENTS
CERTIFICATION ………………………………………………………………………………………………………….. ii
DEDICATION ………………………………………………………………………………………………………………. iii
ACKNOWLEDGEMENT ………………………………………………………………………………………………. iv
ABSTRACT …………………………………………………………………………………………………………………… v
LIST OF FIGURES ……………………………………………………………………………………………………… viii
LIST OF TABLES ………………………………………………………………………………………………………….. x
NOMENCLATURE ………………………………………………………………………………………………………. xi
CHAPTER ONE …………………………………………………………………………………………………………….. 1
1.0 INTRODUCTION …………………………………………………………………………………………………….. 1
1.1 Research Background ………………………………………………………………………………………….. 1
1.2 Problem Statement ………………………………………………………………………………………………. 3
1.3 Aim …………………………………………………………………………………………………………………… 3
1.4 Objectives ………………………………………………………………………………………………………….. 3
1.5 Scope of Study ……………………………………………………………………………………………………. 4
1.6 Motivation/Significance of Study ………………………………………………………………………….. 4
1.7 Justification ………………………………………………………………………………………………………… 4
CHAPTER TWO ……………………………………………………………………………………………………………. 5
2.0 THEORECTICAL BACKGROUND ……………………………………………………………………….. 5
2.1 Biodiesel ……………………………………………………………………………………………………….. 5
2.2 Catalyst ……………………………………………………………………………………………………………. 10
2.4. Vegetable Oil for Transesterification ………………………………………………………………….. 13
2.6. Characterization Methods for Catalyst and Biodiesel ……………………………………………. 15
2.7. Past Work On Biodiesel Production with Catalyst Gotten From Natural Sources …….. 19
CHAPTER 3 ………………………………………………………………………………………………………………… 23
3.0 METHODOLOGY ……………………………………………………………………………………………….. 23
3.1 MATERIALS AND EQUIPMENT……………………………………………………………………… 23
3.2 Catalyst Preparation …………………………………………………………………………………………… 24
3.3 Waste Cooking Oil ……………………………………………………………………………………………. 25
3.4 Biodiesel Production………………………………………………………………………………………….. 28
CHAPTER 4 ………………………………………………………………………………………………………………… 30
4.0 RESULTS AND DISCUSSION …………………………………………………………………………….. 30
vii
4.1 Oil Analysis …………………………………………………………………………………………………. 30
4.2 Oil Characterization ………………………………………………………………………………………. 30
CHAPTER 5 ………………………………………………………………………………………………………………… 38
5.0 CONCLUSION AND RECOMMENDATION ………………………………………………………… 38
5.1 Conclusion …………………………………………………………………………………………………………… 38
5.2 Recommendation ………………………………………………………………………………………………….. 38
REFERENCE ……………………………………………………………………………………………………………….. 39
APPENDIX ………………………………………………………………………………………………………………….. 42
viii
LIST OF FIGURES
Figure 1.1. Transesterification reaction……………………………………………………………2
Figure 2.1. Overall mechanism of Transesterification……………………………………………..6
Figure 2.2. Structure of Vegetable Oil……………………………………………………………14
Figure 2.3. Block diagram of an FTIR spectrometer………………………………………………….19
Figure 3.1. Process for catalyst preparation………………………………………………………26
Figure 3.2. The sieved oil…………………………………………………………………………26
Figure 3.3. pH meter………………………………………………………………………………27
Figure 3.4. Atmospheric mud balance…………………………………………………………….27
Figure 3.5. Marsh funnel………………………………………………………………………….28
Figure 3.6. Process of biodiesel production………………………………………………………29
Figure 3.7. Synthesized biodiesel before separation…………………..…………………………30
Figure 4.1. SEM of raw anthill……………………………………………………….…………..32
Figure 4.2. SEM AT 800 °C…….………………………………………………………………..33
Figure 4.3. SEM AT 1000 °C….…………………………………………………………………33
Figure 4.4. Biodiesel yield against catalyst activation temperature……..………………………..34
Figure 4.5. Biodiesel yield with time……………………………………………………………..35
Figure 4.6. Biodiesel yield with temperature……………………………………………………..35
ix
Figure 4.7. Waste cooking oil FTIR spectrum……………………………………………………36
Figure 4.8. Waste cooking oil derived biodiesel at 800°C……………………………………………36
Figure 4.9. GCMS data…………………………………………………………………………..37
Figure 4.10. GCMS with data band matching number…………………………………………..37
x
LIST OF TABLES
Table 2.1. Properties of biodiesel compared to diesel……………………………………………10
Table 2.2. Comparison of homogenous and heterogeneously catalyzed transesterification..……12
Table 2.3. Compositional analysis of ant-hill clay…………………………………………………13
Table 4.1. Oil analysis result………..…………………………………….…………………………31
Table 4.2. Composition of anthill…………………………………………………………………31
Table 4.3. Fatty acid contents of each oil represent the composition of methyl esters in biodiesel………………………………………………………………………………………….38
xi
NOMENCLATURE
FAME
Fatty Acid Methyl Ester
SEM
Scanning Electron Microscope
FTIR
Fourier Transform Infrared
FFA
Free Fatty Acid
XRF
X-Ray Fluorescence
GC-MS
Gas Chromatograhy-Mass Spectrometry
A/D
Analog to Digital
XRD
X-Ray Diffraction
1
CHAPTER ONE
1.0 INTRODUCTION
1.1 Research Background
Currently there is an urgent need to develop alternative energy resources, such as biodiesel fuel due to the gradual reduction of world petroleum reserves, its economic and social concerns and the environmental pollution of increasing exhaust emissions of harmful gases like SOx, NOx, and Cox, coupled with the steady increase in energy consumption have spurred research interest in alternative and renewable energy sources. A successful substitute for diesel fuel, used mainly in the transportation sector, was found to be the mixture of the ester derivatives from the vegetable oils and animal fats. This new feedstock is environmental friendly, renewable, and totally in- dependent from petroleum
Biodiesel is a renewable, biodegradable fuel that can be manufactured domestically from vegetable oils, animal fats, or recycled restaurant grease. It is a cleaner-burning replacement for petroleum diesel fuel. Biodiesel is defined as the mono-alkyl esters of vegetable oils or animal fats, obtained by transesterification of oils or fats with an alcohol, usually methanol or ethanol. The major component of vegetable oil is triglycerides. When the triglycerides react with alcohol in the presence of base catalyst, this is called “transesterification.” In this reaction, triglycerides are converted to diglyceride, monoglyceride, and finally converted to glycerol. The reaction occurs in three steps. In the first step, a triglyceride reacts with an alcohol molecule producing a diglyceride –ester and then the diglyceride reacts with another alcohol molecule producing a mono-glyceride and another mono-ester, and finally, the mono- glyceride reacts with another alcohol molecule giving glycerin and another mono-ester. (Vonortas and Pappayanakos, 2014)
2
Figure 1.1. Transesterification reaction
The parameters affecting the transesterification reaction are temperature, molar ratio of alcohol to oil, type and quantity of catalyst, the type of the process, and the composition of the reactants mixture.
Catalyst is any substance that increases the rate of a chemical reaction. Catalyst are not consumed during a reaction therefore it is possible to recycle them. The process for producing biodiesel use different catalyst
i. Homogenous (NaOH, KOH, H2SO4)
ii. Biocatalyst (lipases)
iii. Heterogeneous (metal hydroxides, metal complexes and metal oxides like calcium oxide, magnesium oxide, zeolites etc.)
Homogenous catalyst is a catalyst that is in the same phase with the reactant while heterogeneous catalyst means that the catalyst are in different phase with the reactant. Biocatalyst are known as the enzyme catalyst.
It has been estimated that the cost of biodiesel produced from virgin vegetable oil through transesterification is higher than that of fossil fuel, because of high raw material cost. This has
3
hindered wider utilization and commercialization of future biodiesel plant. To minimize the biofuel cost, in recent days, cheaper feedstock such as low-grade oil, typically waste cooking oil is being used as feedstock. The high viscosity and poor volatility are the major limitation of using vegetable oil in diesel engines. (Paugazhabadivu et al., 2005). Large amount of waste cooking oil is generated from eatery establishment, restaurant and food industry etc. every year, discarding of this oil can be of a challenge since it has the probability of contaminating the environment. (Hubera et al., 2007). Accordingly, this research work will focus on biodiesel production from waste cooking oil using thermally activated anthill.
1.2 Problem Statement
Homogenous catalyst result in complex separation and purification process steps due to its high saponification. Catalyst gotten from anthill has never been recorded to be used in biodiesel production based on the previous research. The competition of using edible vegetable oil in the production of biodiesel in place of food stock has made it a wrong choice for biodiesel production. Waste vegetable oil poses an environmental concern in the disposal. Depletion of petroleum reserves makes dependence on it as the only source of energy a problem.
1.3 Aim
This research project is aimed at the investigation of anthill as a suitable catalyst for the production of biodiesel by transesterification.
1.4 Objectives
Preparing the anthill catalyst at varied activation temperature.
Varying the time during biodiesel production
Varying the temperature and time of the reaction
4
1.5 Scope of Study
The scope of my study covers the production of biodiesel using anthill as catalyst. Various samples of the anthill catalyst at various activation temperature will be tested during the biodiesel production while varying the methanol to oil ratio, temperature and time of reaction to find out the optimum conditions for the best conversion of the biodiesel.
1.6 Motivation/Significance of Study
In most of hotels, restaurants, and in other food industries, the waste cooking oil is either simply discharged into the river or dumped into the land, In spite of this, the waste cooking oil can be used effectively for the biodiesel synthesis. Biodiesel production from waste cooking oil is found to be economically feasible method. This research is proposed to improve the capability of waste cooking oil as a biodiesel feedstock in the present worldwide due to the increasing demand of biodiesel, the environmental concern and limited resources of petroleum oil. Many researches before use waste cooking oil to produce but none has used anthill as a catalyst for the biodiesel production. Hence, this research is to investigate if using anthill as a catalyst will give a good yield and the parameter suitable for the yield.
Biodiesel have so many advantages such as, is a renewable energy sources, safe for use in all conventional diesel engines, offers the same performance and engine durability as petroleum diesel fuel, non-flammable and nontoxic, reduces tailpipe emissions, visible smoke and noxious fumes and odors. So, waste cooking oil is used as a raw material to substitutes the petroleum because it provides a safer means of disposing of the oil.
1.7 Justification
Availability of anthill across the nation and abundant quantity of waste cooking oil
DISCLAIMER: All project works, files and documents posted on this website, UniProjectTopics.com are the property/copyright of their respective owners. They are for research reference/guidance purposes only and some of the works may be crowd-sourced. Please don’t submit someone’s work as your own to avoid plagiarism and its consequences. Use it as a reference/citation/guidance purpose only and not copy the work word for word (verbatim). The paper should be used as a guide or framework for your own paper. The contents of this paper should be able to help you in generating new ideas and thoughts for your own study. UniProjectTopics.com is a repository of research works where works are uploaded for research guidance. Our aim of providing this work is to help you eradicate the stress of going from one school library to another in search of research materials. This is a legal service because all tertiary institutions permit their students to read previous works, projects, books, articles, journals or papers while developing their own works. This is where the need for literature review comes in. “What a good artist understands is that nothing comes from nowhere. All creative work builds on what came before. Nothing is completely original.” - Austin Kleon. The paid subscription on UniProjectTopics.com is a means by which the website is maintained to support Open Education. If you see your work posted here by any means, and you want it to be removed/credited, please contact us with the web address link to the work. We will reply to and honour every request. Please notice it may take up to 24 – 48 hours to process your request.
